Hold My Phone Holder Suit Nissan Patrol Y62 - Left Hand Side LH

Click On Phone Mount This Click on Phone Mount has been designed specifically to fit to the dashboard of the Y62 Nissan Patrol Series 1-5 These are designed to be fitted with no holes being drilled into your car These are 1 part of a 2 part solution, they are pre drilled with AMPS pattern holes, ready for you to mount whichever brand or model of phone holder you require or prefer to use but no actual phone holder is supplied in this kit, this is the vehicle mount only.  This ClicOn Fits on the LH side of the radio surround- see pictures for placement Below we have the basic instructions so you can see how they are fitted. 1. Open the glove compartment door. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of the enclosed gap opener into the gap between the dashboard and the glove compartment frame, to widen the gap. Peel off the cover of adhesive tape on the ClicOn.2. Hold the ClicOn in an almost 45 degree angle and press/hook the angled left edge into the gap above the gap opener. Flip/push the ClicOn to the right so the angled edge on the left side of the ClicOn hooks behind the glove compartment frame.3. Place your fingers behind the right side of the ClicOn and pull so it flexes towards you. Then hook it over the console edge and press/slide the curved edge into the gap between the centre console panel and the padded console edge. Pull out the gap opener and close the glove compartment door.