Click On Phone Mount This Click on Phone Mount has been designed specifically to fit to the dashboard of the D23 NP300 Navara Series 1-5 These are designed to be fitted with no holes being drilled into your car These are 1 part of a 2 part solution, they are pre drilled with AMPS pattern holes, ready for you to mount whichever brand or model of phone holder you require or prefer to use But no actual phone holder is supplied in this kit, this is the vehicle mount only. This ClicOn can be placed anywhere within the width of the air vents on the dashboard. Below we have the basic instructions so you can see how they are fitted. 1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of the enclosed gap opener into the gap between the frame surrounding the air vent and the dashboard overhang, to widen the gap. Peel off the adhesive tape covers on the ClicOn. Press the angled edge on the upper part of the ClicOn upward into the gap next to the gap opener. Pull out the gap opener. 2. Press the lower part of the ClicOn upward/forward and hook the angled edge into the gap between the frame surrounding the air vent and the frame surrounding the control panel.
